ST-Link V2 Emulator Debugger and Programming Unit STM8 STM32 compatible with Arduino
Features:
The ST-Link V2 Programming Unit Emulator Downloader, supporting downloading and debugging of the full range of STM32 SWD and STM8 SWIM
The wiring is very simple! It’s convenient and practical because the interface definition is marked directly on the case
It supports both 5V and 3.3V power outputs, and all I/O output ports are protected
You can easily observe the working status with red and blue LED indicators
It can protect your computer motherboard since the internal board of this programmer is with 500MA self-recovery fuse
Supported Software Versions:
1.Supporting the full range of STM32 SWD debugging interface
2.Support the full range of STM8 SWIM download debugging (common development environments such as IAR, STVD etc. are supported); supported software versions as follows:
– ST-LINK Utility 2.0 and 4.2.1 above
– STVD and above
– STVP 3.2.3 and above
– IAR EWARM V6.20 and above
– IAR EWSTM8 V1.30 and above
– KEIL RVMDK V4.21 and above
3.Supports for automatic firmware upgrades